`Dogcow Cutout Page`

Assembly Instructions

Print this page or open the picture in a new window by clicking here and print the picture.
Carefully cut out the head/tail section as well as the body section.
Next, cut two slits in the body where the solid black lines are, this is where you slide the head/tail section into the body.
Fold the body along the dotted lines as well as all for flaps. Glue or tape the flaps to the inside of the body. Also make the two folds on the dotted lines for the head/tail section.
Slide the tail into the front (larger) slit until the head is in place. Then, turn the dogcow over to slide the tail out the back (smaller) slit to complete the tail.

Now that you have completed your dogcow (Clarus), you may now place him on top of your Mac. He prefers to dwell on top of monitors because of the warmth they provide.
Be sure to play with Clarus every time you use your Mac, just pull his tail to make his head move.
Want a dogcow family?, simply print more and ajust the scaling on the page setup to get different size dogcattle. (Hmm... Who's that in the page setup?)